Atlanta Wiffleball Club
Object Strike Zone Design
Atlanta WC's Object Strike Zone (used since 2014) 23.5"x25.5"
This one use 1 1/2"; PVC Piping (Parts are cheaper than the other sizes)
Required pieces
(2) 10' 1 1/2" PVC pipe
(4) T-joints
(10) 90 degree elbow joints we use 1-1/2 in. PVC DWV 90-Degree Hub x Hub Elbow
PVC Glue
PVC Pipe cutter or hacksaw
​
Strike zone face
Top - 19" (1)
Sides 20.5" (2)
Bottom - 3" (2)
Bottom - 8.5" (1)
Back for elbow connection 2.5" (2)
90 degree elbow joints (4)
T-joint (2)
​
Legs (Dont glue)
Legs - 9" (2)
90 degree elbow joint (2)
​
Rectangle base (Glue all)
Base - 8" (6)
T-Joint 1 1/2" (2)
90 Degree Elbow Joint (4)
​
If you glue(strongly recommended): Assemble and measure before glueing
1) Do the sides for the face first and level on board.
2) Base - start with the middle T-joint then add the elbow joints.
3) If you plan on making this portable Do Not glue the legs and elbow joint connecting to Strike zone face.
Object Strike Zone #2 (we need check measurements)
The video one will be 23"x27".
Video uses 1 1/4" PVC piping and will have straight legs (no bend/elbow for legs)
Atlanta WC's - Object Strike Zone is 23x26 give or take
www.youtube.com/watch?feature=iv&v=9U455Hnqtds&annotation_id=annotation_595113
​
​
Design
Strike zone face:
20 3/4 Top (1)
22 1/2" side (2)
10" face bottom (1)
3 1/2" face Bottom (2)
10" (2) Legs
10" base (4)
7"base (2)
90 degree elbow joint 1 1/4"(8)
Tee joint 1 1/4" (4)